Midland 220 Manuel d'utilisateur télécharger pdf (Page 13)

ENGLISH

INSTALLATION

Safety and convenience are the primary considerations for mounting any piece of mobile equipment.

All controls must be readily available to the operator without interfering with the movements

necessary for safe operation of the vehicle. Interference from the connecting cables may contribute

to the loss of control of the vehicle.

Set the proper position in the car to install the transceiver using the supplied supporting bracket or

eventually the DIN mounting bracket.

Tighten the retaining screws. The mounting bracket must be close to metallic parts.

POWER SUPPLY

Be sure the transceiver is OFF. In the direct-voltage power supply, it is very important to observe

the polarity even if the unit is protected against the accidental inversion:

Red = positive pole (+)

Black = negative pole (-)

The same colours are present on the battery and in the fuse box of the car. Correctly connect the

cable terminal to the battery.

INSTALLING AN ANTENNA

1. Place the antenna as high as possible

2. The longer the antenna is, the better will be the performance

3. If possible, mount the antenna in the centre of whatever surface you choose

4. Keep antenna cable away from noise sources, such as the ignition switch, gauges,etc.

5. Make sure you have a solid metal-to-metal ground connection.

6. Prevent cable damage during antenna installation.

WARNING: To avoid damage, never operate your CB radio without connecting a proper antenna.

A periodical control of the cable and of the S.W.R. is recommended.

HOW TO OPERATE YOUR TRANSCEIVER

1. Screw the microphone plug into the microphone jack.

2. Make sure your antenna is connected to the antenna connector.

3. Make sure the SQUELCH control is turned fully conterclockwise.

4. Turn on the unit and adjust the volume control.

5. Select your desired channel.

6. To transmit, press the PTT button and speak in a normal tone of voice.

7. To receive, release the PTT button.

FREQUENCY BAND SELECTION

The frequency bands must be chosen according to the country where you are going to operate.

Procedure:

1. Switch off the unit.

2. Turn it on while pushing the “N.K./ESP” button.

3. Select the desired frequency band by pushing the UP / DOWN buttons (see the chart here

below).

Wait for 5 seconds or switch off and then on the radio.

NOTE1: In the UKE or UKC frequency bands, you can select directly the other band by pushing the

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 67 68

Pas de commentaire

Midland 220 Manuel d'utilisateur Page 13