Midland G10 Manuel d'utilisateur télécharger pdf (Page 21)

Midland G10 instruction guide | 7

ming software.

To enable the Scan function, all 16 channels must be programmed.

If you turn on the radio on channel 16, the scanning will automatically

start.

Whenever any signal is detected, the scanning will stop on a busy chan-

nel.

If the PTT is pressed, you will transmit on the latest busy channel.

Channel 16 is the priority channel, therefore if you don’t pick up any

signal when you press PTT, the radio will transmit on channel 16.

Squelch

The Squelch function suppresses noises on free channels and allows to

receive even weak signals.

G10 has 10 diﬀerent Squelch levels that can be set by programming sof-

tware: 0 means that the Squelch is turned oﬀ; from level 1 to level 9 you

will have diﬀerent levels of noise reduction. The higher is the level, the

louder will be the Squelch.

By default, the Squelch level of G10 is set on level 4.

Make sure you do not set an excessively high squelch level because in this

case you may not be able to receive weaker signals. On the other hand an

excessively low Squelch value could enable the Squelch even when no si-

gnals are present.

Squelch must always be adjusted when no signals are present.

The Time Out timer is settable from 30 sec to 270 sec. only through the

programming software.

This feature is disabled by default.

Battery recharge

G10 is equipped for using a 7,4V Li-ion rechargeable battery pack which

can be recharged connecting the socket of the AC/DC wall adaptor to a

mains power socket and inserting the jack of the wall adaptor into the

desktop charger plug.

It takes 4-5 hours to fully recharge the radio.

For maximum battery life, we recommend charging the battery pack

when the G10 is oﬀ and the battery pack is fully discharged.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 97 98

Pas de commentaire

Midland G10 Manuel d'utilisateur Page 21